Best Dream Car Pumpkin Cutouts

⚡️ Read the full article on Motorious

Use these cutouts to turn your pumpkin into a collectible, sort of.

A few years ago, I printed off a 4th-generation Firebird logo, taped it to a pumpkin, traced it with a push pin, and cut it out. It was my favorite pumpkin, and was a total hit when I shared it online. As I sit here with four pumpkins that are still not Halloween ready, I want to recreate our four vehicles on each, or at least the  - my 1998 Formula (that I'm always mentioning), Dodge Charger 392, Silverado, and my son's Tahoe. And while searching, I found some good car-themed cutouts that I wanted to share. So here are some ideas for the coolest pumpkins around.

This is a little more advanced than the original logo I mentioned, so here are the official directions, per We R Mopar:

• Clean out the inside of you pumpkin and wash the surface with soap and water

• Download and print the PDF file using the greyscale setting under preferences

• Tape the printout over the flattest part of the pumpkin’s face

• Very carefully use a serrated knife to cut out the lines on the sheet

• Pay close attention to the instructions and take your time

And the finished product is pretty cool, just don't be surprised if it gets stolen.

From detailed, to basic, this pumpkin is more my speed, skill wise. Get the download here.

This Porsche GT3 RS cutout comes courtesy of FlatSixes.com, and their finished product is pretty legit.